8FW65P1 LF Drivers 8 inchs
Notes
- 2.5 INCH COPPER VOICE COIL
- 94 dB/SPL SENSITIVITY
- 500 WATT PROGRAM POWER HANDING
- FEM OPTIMIZED MOTOR AND SUSPENSIONS
- OPTIMIZED COOLING SYSTEM
- RESONANCE FREE AND HEAVY DUTY BASKET DESIGN
- 94 dB/SPL SENSITIVITY
- 500 WATT PROGRAM POWER HANDING
- FEM OPTIMIZED MOTOR AND SUSPENSIONS
- OPTIMIZED COOLING SYSTEM
- RESONANCE FREE AND HEAVY DUTY BASKET DESIGN
GENERAL SPECIFICATIONS
| Nominal diameter | 210(8) mm (in.) |
|---|---|
| Nominal impedance | 8 Ω |
| Minimum impedance | 6 Ω |
| Program power (1) | 500 W |
| AES Power rating(2) | 250 W |
| Sensitivity (3) | 94 dB |
| Frequency range | 78 ~ 3500 Hz |
| Voice coil diameter | 65(2.5) mm (in.) |
| Chassis material | Steel |
| Magnet material | Ferrite |
| Magnet dimensions (ODxIDxh) | 156 x 80 x 20 mm |
| Coil material | SV |
| Former material | Glass Fiber |
| Xmax(4) | 5 mm |
| Xmech(5) | 9 mm |
| Gap height | 8 mm |
| Voice coil Winding height | 14 mm |
SMALL SIGNAL PARAMETERS
| DC resistance(Re) | 4.5 Ω |
|---|---|
| Resonance frequency(Fs) | 78 Hz |
| Moving mass(Mms) | 24 g |
| Compliance(Cms) | 0.17 mm/N |
| Force factor(BL) | 13.20 N/A |
| Mechanical Q-factor(Qms) | 3.5 |
| Electrical Q-factor(Qes) | 0.4 |
| Total Q-factor(Qts) | 0.36 |
| Equivalent air volume(Vas) | 17 I |
| Voice coil Inductance(Le) | 0.19 mH |
| Diaphragm area(Sd) | 227 cm2 |
| Reference efficiency(Eta O) | 1.3 % |
SHIPPING INFORMATION
| Net weight | 3.6 Kg |
|---|---|
| Multipack size (2) (W x D x H) | 225 x 225 x 260 mm |
| Multipack weight | 7.5 Kg |
OTHERS
(1)Program power is defined as 3 dB greater than AES Power.
(2) Tested for two hours using a continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested in free air.
(3) From T/S parameters, measured with LMS DA LPM module.
(4) The Xmax is calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height. (5) The Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.
(6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity for 2 hours; b) by LMS LSI measurement.
(2) Tested for two hours using a continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested in free air.
(3) From T/S parameters, measured with LMS DA LPM module.
(4) The Xmax is calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height. (5) The Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.
(6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity for 2 hours; b) by LMS LSI measurement.
