10FW65T1 LF Drivers 10 inchs

Notes

-2.5 INCH COPPER VOICE COIL

-95 dB/SPL SENSITIVITY

-600 WATT PROGRAM POWER HANDING

-FEM OPTIMIZED MOTOR AND SUSPENSIONS

-OPTIMIZED COOLING SYSTEM

-RESONANCE FREE AND HEAVY DUTY BASKET DESIGN

GENERAL SPECIFICATIONS

Nominal diameter 262(10) mm (in.)
Nominal impedance 8 Ω
Minimum impedance 6 Ω
Program power (1) 600 W
AES Power rating(2) 300 W
Sensitivity (3) 95 dB
Frequency range 65 ~ 4000 Hz
Voice coil diameter 65(2.5) mm (in.)
Chassis material Aluminium
Magnet material Ferrite
Magnet dimensions (ODxIDxh) 145 x 75 x 20 mm
Coil material SV
Former material Glass Fiber
Xmax(4) 4.5 mm
Xmech(5) 10 mm
Gap height 10 mm
Voice coil Winding height 14 mm

SMALL SIGNAL PARAMETERS

DC resistance(Re) 4.5 Ω
Resonance frequency(Fs) 65 Hz
Moving mass(Mms) 38 g
Compliance(Cms) 0.20 mm/N
Force factor(BL) 12.80 N/A
Mechanical Q-factor(Qms) 5.7
Electrical Q-factor(Qes) 0.48
Total Q-factor(Qts) 0.44
Equivalent air volume(Vas) 35 I
Voice coil Inductance(Le) 0.50 mH
Diaphragm area(Sd) 346 cm2
Reference efficiency(Eta O) 1.9 %

SHIPPING INFORMATION

Net weight 3.9 Kg
Multipack size (1) (W x D x H) 280 x 280 x 149 mm
Multipack weight 4.4 Kg

OTHERS

(1)Program power is defined as 3 dB greater than AES Power.

(2) Tested for two hours using a continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested in free air.

(3) From T/S parameters, measured with LMS DA LPM module.

(4) The Xmax is calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height. (5) The Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.

(6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity for 2 hours; b) by LMS LSI measurement.