15NDF100U1 LF Drivers 15 inchs
Notes
- 4 INCH COPPER VOICE COIL
- 98 dB/SPL SENSITIVITY
- 1400 WATT PROGRAM POWER HANDING
- FEM OPTIMIZED MOTOR AND SUSPENSIONS
- OPTIMIZED COOLING SYSTEM
- RESONANCE FREE AND HEAVY DUTY BASKET DESIGN
- ALUMINIUM DEMODULATING RING
- 98 dB/SPL SENSITIVITY
- 1400 WATT PROGRAM POWER HANDING
- FEM OPTIMIZED MOTOR AND SUSPENSIONS
- OPTIMIZED COOLING SYSTEM
- RESONANCE FREE AND HEAVY DUTY BASKET DESIGN
- ALUMINIUM DEMODULATING RING
GENERAL SPECIFICATIONS
Nominal diameter | 389(15) mm (in.) |
---|---|
Nominal impedance | 8 Ω |
Minimum impedance | 6.3 Ω |
Program power (1) | 1400 W |
AES Power rating(2) | 700 W |
Sensitivity (3) | 98 dB |
Frequency range | 40 ~ 3000 Hz |
Voice coil diameter | 100(4) mm (in.) |
Chassis material | Aluminium |
Magnet material | Neodymium |
Magnet dimensions (ODxIDxh) | 97 x 25 x 10 mm |
Coil material | SV |
Former material | Glass Fiber |
Xmax(4) | 8.5 mm |
Xmech(5) | 15.5 mm |
Gap height | 12 mm |
Voice coil Winding height | 23 mm |
SMALL SIGNAL PARAMETERS
DC resistance(Re) | 5 Ω |
---|---|
Resonance frequency(Fs) | 40 Hz |
Moving mass(Mms) | 138 g |
Compliance(Cms) | 0.11 mm/N |
Force factor(BL) | 19.8 N/A |
Mechanical Q-factor(Qms) | 8 |
Electrical Q-factor(Qes) | 0.31 |
Total Q-factor(Qts) | 0.3 |
Equivalent air volume(Vas) | 132 I |
Voice coil Inductance(Le) | 1.50 mH |
Diaphragm area(Sd) | 880 cm2 |
Reference efficiency(Eta O) | 2.5 % |
SHIPPING INFORMATION
Net weight | 9.3 Kg |
---|---|
Multipack size (1) (W x D x H) | 410 x 410 x 213 mm |
Multipack weight | 10.3 Kg |
OTHERS
(1)Program power is defined as 3 dB greater than AES Power.
(2) Tested for two hours using a continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested in free air.
(3) From T/S parameters, measured with LMS DA LPM module.
(4) The Xmax is calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height.
(5) The Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.
(6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity for 2 hours; b) by LMS LSI measurement.
(2) Tested for two hours using a continuous, band-limited pink noise signal as per AES 2-1984 Rev. 2003. Loudspeaker tested in free air.
(3) From T/S parameters, measured with LMS DA LPM module.
(4) The Xmax is calculated as: (Hvc - Hg)/2+ Hg/4. Hvc is the voice coil height and Hg the gap height.
(5) The Xmech is calculated as: (Hvc - Hg)/2 +(Hg-2). Hvc is the voice coil height and Hg the gap height.
(6) Thiele-Small parameters are measured after preconditioning: a) at 20°C- 22°C, 50% humidity for 2 hours; b) by LMS LSI measurement.